编程单个SB8F
在对传感器盒进行编程之前，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，直到READING红灯开始闪烁，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，启用了输出。黄灯（STORED）指示启用输出。
Before programming the sensor box, make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for 3 seconds until the READING red light starts fashing, then release it.The red light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).
带端子板的传感器盒
IP66聚苯i乙烯传感器盒。• 可定制的电缆进线和出线，配有标准电缆密封套。• 2个螺钉端子，可直接连接15个输入/输出 。• 随附铝挤压型材直接固定螺钉。• 每个连接线路的zui大开关电流达1A。
IP66 polystyrene sensor box.• Customizable cable input and output with standard cable gland
2 screw terminals with direct connection of 15 inputs/outputs. • Supplied complete with direct fxing screws for aluminum extruded profles.
Maximum switching current up to 1A for each connection line.
双钳口自动校准平行i气动夹具(SGP-S系列)
•双动作。
•反冲调整系统。
•小尺寸高i性能。
•紧固的构造使其非常适合重型作业的运用，使用寿命长，免维护。
•不同的紧固和输送选项。
•随时用于 PRO-SN…HS (1) 可编程磁性传感器。
•食物级润滑油FDA-H1。
Double acting.• Backlash adjusting system.• High performance in small dimensions.• The rugged construction lends itself to heavy duty applicationsfor a trouble free long life without maintenance.
Various fastening and air feeding options.• Ready for PRO-SN …HS (1) programmable magnetic sensor.• Food grade grease FDA-H1.
以上信息由专业从事机器人夹具快速切换器的吉玛泰克于2025/9/1 13:56:59发布
转载请注明来源：http://putian.mf1288.com/jmtkzdh-2885503719.html
上一条：没有了
